Setup
Setting Up One-to-One NAT
Cisco Small Business RV0xx Series Routers Administration Guide 51
3
• To modify a service you created: Click the service in the list. The
information appears in the text fields. Make the changes, and then click
Update. If you do not need to make changes, you can click Add New to de-
select the service and clear the text fields.
• To delete a service from the list: Click the entry that you want to delete. To
select a block of entries, click the first entry, hold down the Shift key, and
click the final entry in the block. To select individual entries, hold down the
Ctrl key while clicking. Click Delete.
Setting Up One-to-One NAT
Use the Setup > One-to-One NAT page to enable One-to-One NAT (Network
Address Translation). This process creates a relationship that maps a valid
external IP address to an internal IP address that is hidden by NAT. Traffic can then
be routed from the Internet to the specified internal resource.
NOTE For best results, reserve IP addresses for the internal resources that you want to
reach through one-to-one NAT. See About Static IP Addresses (for IPv4 Only),
page 66.
You can map a single relationship, or map an internal IP address range to an
external range of equal length (for example, three internal addresses and three
external addresses). The first internal address is mapped to the first external
address, the second IP internal IP address is mapped to the second external
address, and so on.
To open this page: Click Setup > One-to-One NAT in the navigation pane.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
