EasyManuals Logo
Home>Cisco>Network Router>RV042G

Cisco RV042G Administration Guide

Cisco RV042G
199 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #70 background imageLoading...
Page #70 background image
DHCP
Viewing the DHCP Status Information
Cisco Small Business RV0xx Series Routers Administration Guide 70
4
Viewing the DHCP Status Information
Use the DHCP >
Status
page to view the status of the DHCP server and its clients.
You can click Refresh to refresh the data. To release a client’s IP address, you can
click the Delete icon.
To open this page: Click DHCP > DHCP Status in the navigation tree.
DHCP Server
For the DHCP server, the following information is shown:
DHCP Server: The IP address of the DHCP server
Dynamic IP Used: The number of dynamic IP addresses used.
Static IP Used (IPv4 only): The number of static IP addresses used.
DHCP Available: The number of dynamic IP addresses available
Total: The total number of dynamic IP addresses that can be assigned by
the DHCP server.
Client Table
For all network clients using the DHCP server, the Client Table shows the current
DHCP client information. Click the IPv4 tab or the IPv6 tab to view the clients.
Note: The IPv6 tab is available only if you enabled Dual-Stack IP on the Network >
Setup page.
Client Host Name: The name assigned to a client host.
IP Address: The dynamic IP address assigned to a client.

Table of Contents

Other manuals for Cisco RV042G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV042G and is the answer not in the manual?

Cisco RV042G Specifications

General IconGeneral
Ethernet LANYes
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3u
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet interface typeGigabit Ethernet
Ethernet LAN (RJ-45) ports6
Routing protocolsIP, RIP-1, RIP-2
Supported network protocolsPPTP, L2TP, IPSec, PPPoE, DHCP
VPN supportPPTP, Layer 2 Tunneling Protocol (L2TP), IPsec, Dead peer detection (DPD), Internet Key Exchange (IKE), split DNS, VPN backup
Firewall securityStateful packet inspection (SPI) firewall
Security algorithms3DES, 128-bit AES, 192-bit AES, 256-bit AES, DES, HTTPS, IPSEC
VPN tunnels quantity50
Authentication methodSHA-1, MD5
MAC address filtering-
CertificationFCC Class B, CE Class B, UL, cUL, CB
Input current1 A
Output voltage12 V
Storage temperature (T-T)0 - 70 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)5 - 90 %
Operating relative humidity (H-H)10 - 85 %
Product colorBlack
Rack mountingNo
Weight and Dimensions IconWeight and Dimensions
Depth200 mm
Width130 mm
Height38.5 mm
Weight600 g

Related product manuals