Cisco ProtectLink Web
Specifying the Global Settings for Approved URLs and Clients
Cisco Small Business RV0xx Series Routers Administration Guide 115
8
Specifying the Global Settings for Approved URLs and Clients
After you activate your service, you can use the Cisco ProtectLink Web > Global
Settings page to configure the services on the router.
To open this page: Click ProtectLink > Global Settings in the navigation tree.
NOTE This page is available only if you activated your Cisco ProtectLink Web service. See
Getting Started with Cisco ProtectLink Web, page 113.
You can specify approved URLs that the users are always able to access. You also
can specify approved clients who are not subject to the restrictions that you
configure in Web Protection.
To add an entry to the Approved URLs table or the Approved Clients table, click
Add. To delete an entry, click the Delete icon.
NOTE Before navigating away from this page, click Save to save your settings, or click
Cancel to undo them. Any unsaved changes are abandoned.