Security
Password Strength
Cisco Small Business SG200 Series 8-port Smart Switch 149
10
Password Strength
You can use the Password Strength page to configure characteristics of secure
management user passwords.
To configure password strength settings:
STEP 1 Click Security > Password Strength in the navigation window.
STEP 2 Enter the following parameters:
• Strength Check—Select Enable to configure the types of checks to be
performed:
• Minimum Password Length—The minimum number of characters required
for a management user password. Set the minimum password length to a
value in the range of 0–64 characters.
• Password Aging Time—Select the checkbox and enter the time after which
a password expires, from 1–365 days. When a password ages out, the user
must chose a new password before continuing.
• Password Exclude Keyword Check—Select Enable to check for
preconfigured keywords in a password when a user attempts to create or
change the password. The preconfigured keywords are cisco and ocsic.
• Password User Name Check—Select Enable to prevent users from
including their user name in their password when they create or change it.
• Character Can Repeat Itself Consecutively a Maximum of 3 Times—
Select Enable to have the switch check whether any character in the
password is repeated consecutively more than three times.
• Minimum Number of Character Classes—Select the checkbox and enter
the minimum number of character classes that must be represented in the
password string. The four possible character classes are: uppercase letters,
lowercase letters, numbers, and special characters available on a standard
keyboard.
STEP 3 Click Apply and then click Close. Your changes are saved to the Running
Configuration.
To Next Page
Loading...
Need help?
General
