Administration
Management Interface
Cisco Small Business SG200 Series 8-port Smart Switch 34
3
Management Interface
Switch management interface enable access to the web-based switch
configuration utility from a management station on the network. The switch
supports configuration of a management VLAN that segregates the management
traffic from other traffic on the switch.
The management interface can be configured with an IPv4 address or with an IPv6
address. The addresses can be configured statically or they can be obtained
through DHCP/BOOTP servers.
See the following topics for more information on the configuration pages available
in the Administration > Management Interface menu:
• Configuring an IPv4 Management Interface
• Configuring an IPv6 Management Interface
• Viewing and Adding IPv6 Neighbors
Configuring an IPv4 Management Interface
You can use the IPv4 Interface page to configure the management VLAN and IPv4
address.
To configure the IPv4 management interface:
STEP 1 Click Administration > Management Interface > IPv4 Interface in the navigation
window.
STEP 2 Select a management VLAN from the list.
A port must be a member of the management VLAN to gain access to the web-
based switch configuration utility. By default, VLAN 1 is configured as the
management VLAN and all switch ports are configured as members of VLAN 1.
At least one port must be a member of the management VLAN. The Member Ports
list displays all current members of the selected management VLAN.
Note that when you change the management VLAN, you must reassign any
members of the previous management VLAN to the new VLAN to continue their
management access.
To Next Page
Loading...
Need help?
General
