Cisco SG200 Series User Manual

Security
Management Access Profile Rules
Cisco Small Business SG200 Series 8-port Smart Switch 152
10
Modifying and Deleting Access Profiles and Rules
Before you can delete an Access Profile or modify the rules, you must disable the
profile.
To disable an access profile:
STEP 1 Select the profile in the Access Profile Table and click Edit.
STEP 2 Uncheck the Enable box.
STEP 3 Click Apply, and then click Close.
When you finish making changes, re-enable the access profile.
To delete an access profile (after disabling it):
STEP 1 Select the profile in the Access Profile Table.
STEP 2 Click Delete.
To delete a profile rule (after disabling the access profile):
STEP 1 Select the rule in the Profile Rule Table.
STEP 2 Click Delete.
To modify a profile rule (after disabling the access profile):
STEP 1 Select the rule in the Profile Rule Table and click Edit.
STEP 2 Enter the new settings.
STEP 3 Click Apply, and then click Close.
To enable an access profile (after completing all changes):
STEP 1 Select the profile in the Access Profile Table and click Edit.
STEP 2 Check the Enable box.

Cisco SG200 Series Specifications

General

Model	SG200 Series
Layer	Layer 2
Type	Smart Switch
Port Type	Gigabit Ethernet
Form Factor	Desktop or Rack-mountable
Management	SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security	Yes
MAC Address Table	8K
Jumbo Frame Support	Yes
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Humidity	10% to 90% non-condensing
Power Supply	Internal
Ports	8
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps