Cisco SG200 Series User Manual

Administration
LLDP-MED
Cisco Small Business SG200 Series 8-port Smart Switch 86
3
• Management Address—The management interface IP address (see the
IPv4 Interface page or the IPv6 Interface page).
• Port ID SubType—The type of the port identifier.
• Port ID—The port identifier.
• Port Description—The port description.
• System Capabilities Enabled—The capabilities that are enabled on the
switch.
• System Capabilities Supported—The capabilities that are currently
advertised as supported by the switch.
The following switch parameters are advertised in Location TLVs.
• Subtype—The supported type of location information (civic, ELIN, or
coordinate-based).
• Coordinates—Switch GPS coordinates in hexadecimal format, if
coordinate-based location information type is used.
• ELIN Address—The ELIN number, if this location information type is used.
• Country—Country where the city is located, if the civic location information
type is used.
• City—City where the street is located, if the civic location information type
is used.
• Street—Street where the building is located, if the civic location information
type is used.
• Building—Building in which the switch is located, if the civic location
information type is used.

Cisco SG200 Series Specifications

General

Model	SG200 Series
Layer	Layer 2
Type	Smart Switch
Port Type	Gigabit Ethernet
Form Factor	Desktop or Rack-mountable
Management	SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security	Yes
MAC Address Table	8K
Jumbo Frame Support	Yes
Operating Temperature	0 to 40°C (32 to 104°F)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Humidity	10% to 90% non-condensing
Power Supply	Internal
Ports	8
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps