Cisco SPA 508G Administration Guide

Configuring Security, Quality, and Network Features
Setting Security Features
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 119
5
To enable the secure call service:
STEP 1 Log in to the configuration utility.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the Phone tab.
STEP 4 In the Supplementary Services section, under Secure Call Serv, choose yes.
STEP 5 Click Submit All Changes.
NOTE This feature can also be configured from the User tab, under Supplementary
Services.
Users can enter *18 to Secure Next Call—Uses encrypted media for the next
outbound call (on this call appearance only). This star code is redundant if all
outbound calls are secure by default.
The phone can be configured for secure provisioning using the factory-installed
security certificate. To determine if the Client Certificate is installed on the phone:
• SPA 50XG: Press the Setup button and select Product Info. Scroll to Client
Cert.
• SPA 525G/G2: Press the Setup button and select Status. Select Product
Information. Scroll to Certificate.
• WIP310: Log in to the configuration utility. In the Info tab, under Product
Information, certificate information is listed in the Client Certificate field.
Secure Call Indication Tone
This tone is played when a call has been successfully switched to secure mode. It
should be played only for a short while (less than 30 seconds) and at a reduced
level (less than -19 dBm), so it does not interfere with the conversation. You can
configure it on the
Regional web page under Call Progress Tones .
Defaults to 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/2)

Cisco SPA 508G Specifications

General

Speakerphone	Yes
Dialer location	Base
Mac compatibility	No
Ethernet LAN (RJ-45) ports	2
Display resolution	128 x 64 pixels
Display number of colors	Monochrome
Headphone connectivity	2.5 mm

Weight and Dimensions

Depth	212 mm
Width	214 mm
Height	44 mm
Weight	900 g