Cisco SPA 508G Administration Guide

Configuring the Cisco SPA 500S Attendant Console
Setting Up the Cisco SPA 500S Attendant Console
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 191
9
This is entered in the file sip.conf:
[3500]
type=friend
secret=3500
callerid="spa3500"<3500>
nat=no
context=home
mailbox=3500
Subscribecontext=home
...
...
Configuring the Cisco SPA 500S
Complete the configuration required for the extensions on your IP PBX and obtain
the following information:
• IP PBX IP address or other hostname
• Phone extension numbers
To configure the Cisco SPA 500S:
NOTE Steps 1 through 4 are only required when the Server Type field is set to SPA9000.
These steps are not required for other server types such as BroadSoft and
Asterisk.
STEP 1 Connect to the configuration utility for the phone to which the Cisco SPA 500S is
connected.
STEP 2 Click Admin/Advanced on the configuration utility page.
STEP 3 Click the SIP tab.
STEP 4 Select yes from the CTI Enable drop-down list.
STEP 5 Click the Attendant Console tab.
STEP 6 Select yes from the Unit 1 Enable drop-down list. If you have installed two Cisco
SPA 500S units, also select yes from the
Unit 2 Enable drop-down list.

Cisco SPA 508G Specifications

General

Speakerphone	Yes
Dialer location	Base
Mac compatibility	No
Ethernet LAN (RJ-45) ports	2
Display resolution	128 x 64 pixels
Display number of colors	Monochrome
Headphone connectivity	2.5 mm

Weight and Dimensions

Depth	212 mm
Width	214 mm
Height	44 mm
Weight	900 g