Cisco SRP521W User Manual

Administration Settings
Remote Management
Services Ready Platform SRP 500 Series Administration Guide 132
8
SNMP
SNMP is a popular network monitoring and management protocol. The SRP 500
Series platform supports SNMPv2.
STEP 1 Click Administration on the tab and then click Remote Management in the
navigation pane. Click SNMP. The SNMP page appears.
STEP 2 Click Enabled to enable SNMP.
STEP 3 Choose a trusted IP setting.
ACS URL The URL for ACS. The format should be http(s)://
xxx.xxx.xxx.xxx:port or xxx.xxx.xxx.xxx:port. The
xxx.xxx.xxx.xxx is domain name or IP of ACS server;
and after “:” is port. Both IP and port must be filled.
ACS Username The username for ACS. The default username is OUI-
Serial Number; this should be the same as configured at
ACS side and must be filled.
ACS Password The password for ACS. This should be the same as
configured at ACS side and must be filled.
Connection Request
URL
This field will be auto-filled and does not need to be
filled manually. The format is http://xxx.xxx.xxx.xxx:port.
The xxx.xxx.xxx.xxx is the WAN IP of the CPE.
Connection Request
Username
Connection request username. This should be the same
as configured at ACS side.
Connection Request
Password
Connection request password.This should be the same
as configured at ACS side.
Periodic Inform
Interval
The periodic inform interval. The default value is 86400
seconds.
Periodic Inform
Enable
To enable or disable periodic inform.
Request Download If applied, ACS may call the Download RPC after it
receives the request from the CPE.
Field Description

Cisco SRP521W Specifications

General

Brand	Cisco
Model	SRP521W
Category	Wireless Router
Language	English