Setting up the Interfaces of the Services Ready Platform
Setting up the Wireless LAN
63 Services Ready Platform SRP 500 Series Administration Guide
4
Setting up the Wireless LAN
Basic Wireless Settings
The basic settings for wireless networking are set on this page.
There are two ways to configure the wireless network(s) of the Services Ready
Platform, manual and Wi-Fi Protected Setup. To manually configure the wireless
settings, use the Basic Wireless Settings page.
If you have client devices, such as wireless adapters, that support Wi-Fi Protected
Setup, then you can use Wi-Fi Protected Setup to automatically configure wireless
security for your wireless network(s). To use Wi-Fi Protected Setup, refer to your
wireless adapter's documentation.
STEP 1 Click Interface Setup on the tab, and click WiFi Setting, and in the navigation pane.
Click Basic Wireless Settings. The Basic Wireless Settings page appears.
STEP 2 From the Network Mode menu, you can select the wireless standards running on
your network.
• If you have Wireless-N, Wireless-G, and Wireless-B devices in your network,
use the default setting, Mixed.
• If you have only Wireless-G and Wireless-B devices in your network, select
BG-Mixed. If you have only Wireless-N devices, select Wireless-N Only.
Field Description
Mode The Port Settings Mode is IP Phone + Desktop, the ports
in the VLAN are voice enabled.
Enabled Flow
Control
LAN Flow control. To enable flow control, click the
Enable Flow Control box for the LAN interface and click
Submit. Flow control is enabled by default.
Speed Duplex Network speed settings. The default setting is Auto-
negotiate.
Port Details The Port Details area shows information about your
ports.
To Next Page
Loading...
Need help?
General
