4
Services Ready Platform SRP 500 Series Administration Guide 40
Setting up the Interfaces of the Services
Ready Platform
You can use the Inteface Setup pages to setup the WAN, LAN, and Wireless LAN
interfaces.
• Setting up the WAN Interface, page 40
• Setting up the LAN Interface, page 56
• Setting up the Wireless LAN, page 63
• Using the Management Interface, page 76
Setting up the WAN Interface
Internet Setup
The settings for WAN networking are set on these pages. In most cases, you can
configure the Services Ready Platform and get it working properly by using only
the settings on these pages.
NOTE After you configure interfaces settings, you should set a new password for the
Services Ready Platform using the Adminstration > Access Setting page. This
precaution increases security, protecting the Services Ready Platform from
unauthorized changes. All users who try to access the web-based Configuration
Utility will be prompted for the password of the Services Ready Platform.
STEP 1 Click Interface Setup on the tab and then click WAN in the navigation pane. The
Internet Setup page appears.
STEP 2 To add or edit interfaces in the WAN Interface List, click the add or edit icons.
To Next Page
Loading...
Need help?
General
