Setting up the Interfaces of the Services Ready Platform
Setting up the Wireless LAN
71 Services Ready Platform SRP 500 Series Administration Guide
4
Advanced Wireless Settings
This feature is used to set up the advanced wireless functions of the Services
Ready Platform. These settings should be adjusted only by an expert
administrator; incorrect settings can reduce wireless performance.
NOTE To change these settings, wireless must first be enabled.
STEP 1 Click Interface Setup on the tab and then click WiFi Setting in the navigation pane.
Click Advanced Wireless Settings. The Advanced Wireless page appears.
STEP 2 From the Select a SSID menu, choose the beacon interval and RTS threshold
settings to apply to the SSID.
STEP 3 Enter a value in the RTS Threshold field. If you encounter inconsistent data flow,
enter only minor reductions. The default value of 2346 is recommended.
Access Restriction
Prevent Select this option to prevent devices with the MAC
address in the table from accessing the wireless
network. This button is selected by default.
Permit Select this option to allow devices with the MAC
address in the table to access the wireless network.
This button is not selected by default.
Show Client List This button give you access to the Wireless Client List
page. This page shows computers and other devices on
the wireless network. The list can be sorted by Client
Name, Interface, IP Address, MAC Address, and Status.
MAC Address Table
01-32 The MAC addresses of the devices whose wireless
access you want to block or allow.
Field Description
To Next Page
Loading...
Need help?
General
