Setting up the Interfaces of the Services Ready Platform
Using the Management Interface
Services Ready Platform SRP 500 Series Administration Guide 76
4
Using the Management Interface
The Management Interface is set on this page. It allows two loopback interfaces.
STEP 1 Click Interface Setup on the tab and then click Management Interface in the
navigation pane. The Management Interface page appears.
STEP 2 Click on the loopback icon to change the IP address and subnet mask for each
loopback interface. The Management Interface page opens.
STEP 3 Enter the IP Address and Subnet Mask for each interface.
STEP 4 Click Submit to save your settings.
Field Description
WMM Support If you have other devices on your network that support
WMM Support, select Enabled.
No
Acknowledgement
Select Enabled to disable the acknowledgement
feature, so the Services Ready Platform will not resend
data if an error occurs. Otherwise, use the default
setting, Disabled.
To Next Page
Loading...
Need help?
General
