Setting up the Interfaces of the Services Ready Platform
Setting up the LAN Interface
Services Ready Platform SRP 500 Series Administration Guide 56
4
Setting up the LAN Interface
DHCP Server
DHCP Server settings are configured on this page. After clicking Add Entry button,
you can create another DHCP Server Pool.
STEP 1 Click Interface Setup on the tab and then click LAN in the navigation pane. The
DHCP Server page appears.
STEP 2 You can edit or delete a DHCP entry by clicking the edit or delete icon.
STEP 3 Click Add Entry to open the DHCP Add page. From this page you can add a DHCP
entry.
STEP 4 Click Submit to save your settings.
Connection
Validation Site
A ping target for the Services Ready Platform to use to
detect the status of the Internet connection. By default
the Services Ready Platform pings the Network Time
Protocol (NTP) servers. You may specify a different IP
address as a target here.
WAN Interfaces This area provides information on current status of the
Internet connection and Mobile Network connection.
You can click the Status hyperlink to view the details.
You may also configure the interface priority by clicking
Up or Down. Note that the interface priority setting is
configurable only when Connection Recovery is
disabled.
Field Description
To Next Page
Loading...
Need help?
General
