Setting up the Interfaces of the Services Ready Platform
Setting up the WAN Interface
Services Ready Platform SRP 500 Series Administration Guide 54
4
STEP 1 Click Interface Setup on the tab and then click Failover & Recovery in the
navigation pane. The Failover & Recovery page appears.
STEP 2 If necessary, enable the Ethernet Connection Recovery feature by clicking
Enabled. When this option is enabled, the Services Ready Platform sets the
ethernet interface to the highest priority. Enabling this feature also enables the
Interface Connection Failover feature. Whenever the Internet connection fails, the
Services Ready Platform automatically attempts to bring up the mobile network
connection on the USB interface (if available). Whenever the Ethernet Internet
connection recovers, the Services Ready Platform automatically attempts to bring
back and recover the Ethernet Internet connection.
NOTE Your Mobile Connection Mode must be set to Auto to use the Ethernet Connection
Recovery feature.
STEP 3 If necessary, enter an ethernet timeout value.
STEP 4 Choose a site on which to perform failover validation in the Failover Validation Site
area, either use the Services Ready Platform or enter the IP address for a custom
site.
STEP 5 If necessary, change the priority of the WAN interfaces by clicking the Up or Down
buttons.
STEP 6 Click Submit to save your settings.
To Next Page
Loading...
Need help?
General
