Cisco TelePresence SX20 Quick Set - Serialport Settings; Serialport Baudrate; Serialport Loginrequired; Serialport Mode

D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
121
Cisco TelePresence SX20 Quick Set Administrator Guide
SerialPort settings
SerialPort Mode
Enable/disable the serial port (connection via USB and RS-232 adapter).
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: Disable the serial port.
On: Enable the serial port.
SerialPort BaudRate
Define the baud rate (data transmission rate, bits per second) for the serial port.
Other connection parameters for the serial port are: Data bits: 8; Parity: None; Stop bits: 1;
Flow control: None.
Requires user role: ADMIN, INTEGRATOR
Default value: 38400
Value space: 9600/19200/38400/57600/115200
Set a baud rate from the baud rates listed (bps).
SerialPort LoginRequired
Define if login shall be required when connecting to the serial port.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: The user can access the codec via the serial port without any login.
On: Login is required when connecting to the codec via the serial port.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings