Cisco TelePresence SX20 Quick Set - Standby Settings; Standby Delay; Standby Standbyaction; Standby Wakeupaction

D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
126
Cisco TelePresence SX20 Quick Set Administrator Guide
Standby settings
Standby Control
Define whether the system should go into standby mode or not.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: The system will not enter standby mode.
On: The system will enter standby mode when the Standby Delay has timed out.
Requires the Standby Delay to be set to an appropriate value.
Standby Delay
Define how long (in minutes) the system shall be in idle mode before it goes into standby
mode. Requires the Standby Control to be enabled.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..480)
Set the standby delay (minutes).
Standby BootAction
Define the camera position after a restart of the codec.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: RestoreCameraPosition
Value space: None/DefaultCameraPosition/RestoreCameraPosition
None: No action.
RestoreCameraPosition: When the video system restarts, the camera returns to the
position that it had before the restart.
DefaultCameraPosition: When the video system restarts, the camera moves to the
factory default position.
Standby StandbyAction
Define the camera position when going into standby mode.
Requires user role: ADMIN, INTEGRATOR
Default value: PrivacyPosition
Value space: None/PrivacyPosition
None: No action.
PrivacyPosition: When the video system enters standby, the camera turns to a sideways
position for privacy.
Standby WakeupAction
Define the camera position when leaving standby mode.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: RestoreCameraPosition
Value space: None/RestoreCameraPosition/DefaultCameraPosition
None: No action.
RestoreCameraPosition: When the video system leaves standby, the camera returns to
the position that it had before entering standby.
DefaultCameraPosition: When the video system leaves standby, the camera moves to
the factory default position.
Standby WakeupOnMotionDetection
Automatic wake up on motion detection is a feature that will sense when a person walks
into the room. The feature is based on ultrasound detection, and the Proximity Mode setting
must be On to make the feature work.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: The wake up on motion detection is disabled.
On: When people walk into the room the system will automatically wake up from standby.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings