D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
15
Cisco TelePresence SX20 Quick Set Administrator Guide
Switch on
If the video system does not
start automatically, press the
power button gently.
While starting up the LEDs are
lit. The light is circling during
startup. The LEDs light steadily
when the video system is ready
for use.
Switch off
Press the power button gently
and hold until the light goes out
completely.
Enter/exit standby mode
Press the power button briefly.
It takes a few seconds before
the unit enters standby.
Power button with LEDs
encircling the button
Power On and Off
Power On/Off with the Power button
The power button is placed on the top lid as shown in the illustration. There is a ring of LEDs encircling the button.
Restart and standby using the user
interface
Restart the system
1. Select the settings icon (cogwheel) in the status bar of
the user interface.
2. Select Settings, followed by Restart.
3. Select Restart again to confirm your choice.
Enter/exit standby mode
1. Select the settings icon (cogwheel) in the status bar of
the user interface.
2. Select Standby.
Power Off or restart the system remotely
Sign in to the web interface and navigate to Maintenance >
Restart.
Restart the system
Click Restart device... and confirm your choice.
It takes a few minutes before the system is ready for use.
Power Off the system
Click Shutdown device... and confirm your choice.
You cannot power the system on again remotely;
you have to use the power button.
To Next Page
Loading...
