D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
49
Cisco TelePresence SX20 Quick Set Administrator Guide
You can connect two input sources to the codec: a
camera, and a computer (or other content source).
Sign in to the web interface and navigate to Setup >
Configuration, to find the settings referred below.
Connect a camera
Connector 1 (combined HDMI and camera control) is a dedicated
camera connector.
Refer to the ►Connector pin-out schemes appendix for more
information about the camera connector.
The following Cisco cameras are supported:
• PrecisionHD 1080p 2.5x
• Precision 40 (PrecisionHD 1080p 4xS2)
• PrecisionHD 1080p 12x
Connect a computer
Connect a computer to the Connector 2 (DVI-I) in order to share
content locally or with conference participants.
To get audio when using DVI-I, you must also connect the
computer to the codec’s Audio Line input (mini-jack).
Connector 2 (DVI-I)
Audio Line input
Computer input
Connector 1
(HDMI and
camera control)
Connect input sources (page 1 of 2)
To Next Page
Loading...
