D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
50
Cisco TelePresence SX20 Quick Set Administrator Guide
Connect input sources (page 2 of 2)
Set type and name for an input source
We recommend that you set type and name for an input source:
• Video > Input > Connector n > InputSourceType
• Video > Input > Connector n > Name
These settings determine the names and icons that are shown
on the user interfaces. Intuitive names and icons make source
selection easier.
About video and content quality
Use the Video > Input > Connector n > Quality setting to optimize
quality with respect to motion or sharpness.
Typically, you should choose Motion when a large number of
participants are present or when there is a lot of motion in the
picture. Choose Sharpness when you want the highest quality of
detailed images and graphics.
The default value is Motion for Connector 1; and Sharpness for
Connector 2.
To Next Page
Loading...
