D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
16
Cisco TelePresence SX20 Quick Set Administrator Guide
There is a ring of LEDs encircling the power button.
Steady light:
The codec is ready for use.
The LEDs are pulsating slowly:
The codec is in standby mode.
The LEDs are flashing:
The codec calls for attention, e.g. when there is
no LAN connection.
The light from the LEDs circles clockwise:
The codec is starting up (booting), and is not yet
ready for use.
The LEDs light red:
The camera connector is in serial mode (camera
control is disabled).
LED indicator
Power button with
LED indicator
To Next Page
Loading...
