Cisco TelePresence SX20 Quick Set - Cameras settings

D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
82
Cisco TelePresence SX20 Quick Set Administrator Guide
Cameras settings
Cameras Camera [1] Backlight DefaultMode
This configuration turns backlight compensation on or off. Backlight compensation is
useful when there is much light behind the persons in the room. Without compensation the
persons will easily appear very dark to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
Value space: Off/On
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
Cameras Camera [1] Brightness Mode
Define the camera brightness mode.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Manual
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set
using the Cameras Camera [n] Brightness DefaultLevel setting.
Cameras Camera [1] Brightness DefaultLevel
Define the brightness level. Requires the Cameras Camera [n] Brightness Mode to be set to
Manual.
Requires user role: ADMIN, INTEGRATOR
Default value: 20
Value space: Integer (1..31)
The brightness level.
Cameras Camera [1] Flip
With Flip mode (vertical flip) you can flip the image upside down. Flipping applies both to
the self-view and the video that is transmitted to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Off/On
Auto: If the camera detects that it is mounted upside down, the image is automatically
flipped. If the camera cannot auto-detect whether it is mounted upside down or not, the
image is not changed.
Off: Display the image on screen the normal way.
On: Display the image flipped upside down. This setting is used when a camera is
mounted upside down, but cannot automatically detect which way it is mounted.
Cameras Camera [1] Focus Mode
Define the camera focus mode.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/AutoLimited/Manual
Auto: The camera will do single shot auto focusing once a call is connected, as well as
after moving the camera (pan, tilt, zoom).
AutoLimited: Not applicable.
Manual: Turn the autofocus off and adjust the camera focus manually.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings