Cisco TelePresence SX20 Quick Set - Cameras Camera [1] Whitebalance Level; Cameras Camera [1] Whitebalance Mode; Cameras Powerline Frequency; Cameras Preset Triggerautofocus

D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
84
Cisco TelePresence SX20 Quick Set Administrator Guide
Cameras Camera [1] Whitebalance Mode
Define the camera white balance mode.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: Auto/Manual
Auto: The camera will continuously adjust the white balance depending on the camera
view.
Manual: Enables manual control of the camera white balance. The white balance level is
set using the Cameras Camera [n] Whitebalance Level setting.
Cameras Camera [1] Whitebalance Level
Define the white balance level. Requires the Cameras Camera [n] Whitebalance Mode to be
set to manual.
Requires user role: ADMIN, INTEGRATOR
Default value: 1
Value space: Integer (1..16)
The white balance level.
Cameras PowerLine Frequency
If your camera supports power line frequency anti-flickering, the camera is able to
compensate for any flicker noise from the electrical power supply. You should set this
camera configuration based on your power line frequency. If your camera supports auto
detection of line frequency, you can select the Auto option in the configuration.
All Cisco Precision cameras support both anti-flickering and auto detection of line
frequency. Auto is the default value, so you should change this setting if you have a camera
that does not support auto detection.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
Value space: 50Hz/60Hz/Auto
50Hz: Use this value when the power line frequency is 50 Hz.
60Hz: Use this value when the power line frequency is 60 Hz.
Auto: Allow the camera to detect the power frequency automatically.
Cameras Preset TriggerAutofocus
The current position (pan and tilt), zoom and focus are stored with a preset. Use this setting
to determine if the camera should refocus or use the focus value that is stored with the
preset.
Requires user role: ADMIN
Default value: Auto
Value space: Auto/Off/On
Auto: Whether the camera refocuses or not when selecting a preset, depends on the
camera type.
Off: The focus value that is stored with the preset will be used. The camera will not
refocus when selecting a preset.
On: The camera will refocus when selecting a preset. The focus value that is stored with
the preset may be overridden.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

System settings