D15329.08 SX20 Administrator Guide CE9.2, NOVEMBER 2017. www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
145
Cisco TelePresence SX20 Quick Set Administrator Guide
Video Selfview OnCall Mode
This setting is used to switch on self-view for a short while when setting up a call. The
Video Selfview OnCall Duration setting determines for how long it remains on. This applies
when self-view in general is switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: Self-view is not shown automatically during call setup.
On: Self-view is shown automatically during call setup.
Video Selfview OnCall Duration
This setting only has an effect when the Video Selfview OnCall Mode setting is switched
On. In this case, the number of seconds set here determines for how long self-view is
shown before it is automatically switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..60)
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
To Next Page
Loading...
