Single Point Setup
Cluster Firmware Upgrade
Cisco WAP571/E Administration Guide 185
12
• Firmware-transfer-status—Shows whether the firmware download and
validation in cluster member is None/Started/Downloaded/Success/Fail/
Abort_admin/Abort_local/Dap_resigned.
• Firmware-transfer-progress-bar—Shows the progress bar for firmware
download.
To select the cluster member for upgrade:
STEP 1 Select Single Point Setup > Cluster Firmware Upgrade in the navigation pane.
STEP 2 Select the checkbox of the AP to be upgraded.
STEP 3 Click Save.
To get the latest cluster firmware upgrade status:
Click Refresh.
To upgrade the firmware on a cluster member using TFTP:
STEP 1 Select TFTP for Transfer Method.
STEP 2 Enter a name (1 to 128 characters) for the image file in the Source File Name field,
including the path to the directory that contains the image to upload.
For example, to upload the ap_upgrade.tar image located in the /share/builds/ap
directory, enter: /share/builds/ap/ap_upgrade.tar
The firmware upgrade file supplied must be a tar file. Do not attempt to use bin
files or files of other formats for the upgrade; these types of files do not work.
The filename cannot contain the following items: spaces, <, >, |, \, : , (, ), &, ; , #, ? , *,
and two or more successive periods.
STEP 3 Enter the TFTP Server IPv4 Address and click Start-Upgrade.
Upgrading Using HTTP
To upgrade using HTTP:
To Next Page
Loading...
Need help?
General
