Page 33 | 53
• Enable Set Date/Time Manually: Select the date and time manually, and then click Save, the system
automatically synchronizes with the manually set time.
• Enable Synchronize with the computer: Click Save, the system automatically synchronizes the time
to the computer that logs into the WEB page.
• Enable Receive Date/Time from NTP: Select the NTP server (or select a custom server, enter the
custom server domain name), select the time zone where the device is located, enter the NTP port,
set the NTP update interval, date format, date separator, time format, click "Save", system time, and
then the NTP server time is synchronized.
The date setting parameters are described in the following table:
Select the server domain name where the NTP service is installed.
When the NTP server selects "Custom", enter the NTP server domain name.
Date Format
Set the date display format for NVR devices, including Year Month Day,
Month Day Year, Day Month Year, Day Month Year.
Set the time format of NVR devices, including 24-hour and 12-hour.
Set the separator between year, month, and day.
Set the time zone of the NVR device.
Channel Check Time Select the NVR channel.
Table 7-37
Set the channel check time as follows:
1. Access the main interface, click Configuration → System → General → Date to enter the date setting
interface, Figure 7-37.
2. Select the channel or select "All", and then click Save to complete the configuration.
7.1.3 DST
1. Access the main interface, click Configuration → System → General → DST to enter the DST setting
interface, Figure 6-20.
2. Turn on daylight-saving time, set the type, start time, end time, and offset.
3. Click Save to complete the configuration.
To Next Page
Loading...
