Page -20- Clarke
®
Operator's Manual -Encore S20/L20
WARNING: Maintenance and repairs must be
done by authorized personnel only.
WARNING: Always empty the solution tank and
recovery tank before doing any
maintenance.
WARNING: Keep all fasteners tight.
These Maintenance Procedures Must Be Done Ev-
ery Day
Keep the machine clean, it will need fewer repairs and
have longer life.
Do These Procedures When You Begin Your Work
Period
NOTE: Always engage the parking brake (if
equipped) before servicing the machine.
1. Disconnect the plug on the charger from the
connector on the back of the machine. See
figure 1
2. Join the connector from the batteries (1) to the
control panel cable connection. See figure 1.
3. Make sure the recovery tank lid is on correctly.
See figure 2.
4. Make sure the Screen filter over the vacuum motor
is clean and in position. See figure 2 (a)
5. Make sure the valves on the drain hoses are clean.
Tightly close the valves.
6. Make sure brush housing and skirt are in
position on the brush head.
7. Make sure the brush is in position and
installed correctly
8. Check the installation of the squeegee and
squeegee hose.
MAINTENANCE
Figure 1
Figure 2
A
To Next Page
Loading...
Need help?
General
