FreeSpeak II for Eclipse | User Guide
clockwise to decrease volume. The current volume level for the channel is shown on
screen.
4.3.6 Entering and exiting Menu mode
Use Menu mode to:
l
Configure the settings for the beltpack.
l
Read beltpack information such as software version
l
Perform a site survey to maximize signal strength and coverage.
To enter Menu mode, press and hold the Menu key for three seconds. To exit Menu mode,
press the Menu key again.
For more information about using Menu mode on the beltpack, see Introduction to
programming on the beltpack on page 42.
4.3.7 Setting and Adjusting Listen Levels
You can adjust a beltpack’s incoming audio volume in two ways:
l
The master volume level for the beltpack can be set by using the beltpack menu options.
See Configuring the beltpack volume settings on page 44.
l
The incoming audio level can be adjusted during talk or listen on the beltpack using the
beltpack’s rotary level controls.
To adjust the listen level during talk or listen from the beltpack:
l
During talk and listen, use the rotary level control to increase or decrease the incoming
volume level (“listen level”) for that assignment.
Note: You can also configure the incoming audio volume using the EHX software.
4.3.8 Upgrading beltpack firmware
You can upgrade the FreeSpeak II beltpack firmware by:
l
Using a USB connection (the upgrade file for USB has a .fws extension).
l
Using an Over The Air upgrade.
4.3.9 Upgrading by USB connection
1. Connect the beltpack to a USB port on the computer running the EHX software.
2. Select Tools > Apply Wireless Firmware Via USB.
3. Browse to the location of the upgrade file, and then select Update Firmware. The upgrade
file for USB has a .fws extension.
Page 40
To Next Page
Loading...
Need help?
General
