Chapter 3: Operate the system
Use a phone or fax machine 45
3333
To hold a call
During a local or external call, you may place the initial call on hold while
another call is made.
How to put a call on hold depends on the type of phone. For analog 2-wire
phones with an R key follow the instructions in the table below.
For information how to hold a call using the AVIATOR Wireless Handset see
the user manual of the AVIATOR Wireless Handset.
If you want to: Do as follows:
Place a call on hold. Press R 2 #.
Place the existing call on
hold and establish a new
call.
Press R and dial the second phone number
followed by #.
Shuttle between the two
calls.
Press R 2 #
(irrespective of whether the second call
was acquired using Call Hold or acceptance
of Call Waiting.)
Clear the held call, if no
waiting call exists.
Press R 0 #.
Clear an active call and
return to the held call.
Press R 1 #.
Note that this is only possible if no waiting
call exists.
The SwiftBroadband system only supports one circuit-switched
call at a time per AVIATOR 200/300/350 system.
To Next Page
Loading...
