Chapter 3: To use easyMail
Set up ENIDs 53
3333
3. Select whether you want to receive System Messages or SafetyNET
messages or both.
4. To change the Coastal Warning Areas, type in the new areas under
Coastal Warning Areas [A..Z].
5. Select the types of EGC service you want to receive.
6. If you want to receive EGCs at specific positions on your route, select
Fixed positions and fill in the position information for each point on
the route.
7. Click OK.
Set up ENIDs
ENIDs (EGC Network IDentification) are used for identifying the SAILOR
3027 on the network in order for the terminal to receive FleetNET EGCs.
ENIDs must be set up with your LES operator and downloaded to your
SAILOR 3027 before you can use them.
To set up the ENIDs, do as follows:
1. Select Setup > ENIDs.
The ENIDs are listed with provider, ENID and status.
2. Select the ENIDs you want to enable.
3. Click OK.
To Next Page
Loading...
