COBHAM SAILOR 6130 - Set up Password Protection; Set the Language

Chapter 3: To use easyMail
60 Set up password protection
Set up password protection
You can add password protection to three different actions: Transmission,
configuration and remote configuration.
To add password protection, do as follows:
1. Select Setup > Passwords.
2. Select the password you want to add or change.
3. Type in the old password (leave empty if there was no password
protection).
4. Type in the new password under New password and again under
Confirm password.
5. Click OK and close easyMail.
With the password protection, easyMail will ask for a password when a
person tries to access the password protected areas (transmit a message,
configure the system or configure the system remotely).
To remove the password, repeat the above procedure and leave the fields
with the new password empty.
Set the language
To change the language in easyMail, do as follows:
1. Select Setup > Language.
2. Select the language you want in easyMail.
3. Select at the bottom whether you want to show the language selection
at startup.
4. Click OK.