98-175666-A Appendix F: Event messages F-3
List of events
08077-0 ADM WARNING BUC LO frequency
invalid
The satellite modem provided an invalid BUC LO
frequency. A default BUC LO frequency is assumed
based on antenna type. To remove this warning re-
configure the modem to provide a valid BUC LO
frequency. (!T)
08078-0 ADM WARNING VMU TX frequency
invalid
The satellite modem did not provide a Tx
frequency, or it is invalid. A default Tx frequency is
assumed, but this may degrade Tx performance. To
remove this warning re-configure the modem to
provide the correct Tx frequency. (!T)
0807A-0 ADM WARNING Automatic azimuth
calibration pending
Automatic azimuth calibration mode is enabled.
The system tries to perform an azimuth calibration
using the target satellite whenever satellite data is
received from the modem. After successful
calibration the feature is automatically disabled and
the system returns to normal operation. WARNING:
If a system has not completed azimuth calibration
after the installation, the blocking zones may
appear to be at wrong angles. (!T)
0807B-0 ADM WARNING OTC required
(Calibration
outdated)
BUC calibration is outdated. Rerun it from the Core
Module by using the One Touch Commissioning in
the web interface. (!T,!V,!S)
0807E-0 ADM WARNING Keyline signal The keyline signal on the dual antenna master does
not match the keyline signal on the slave. Check
that the keyline splitter cable is connected to the
RS422 connectors. When fixed, the ACU's needs to
be rebooted to clear the event. (!S,!V)
0807F-0 ADM WARNING Local administration
enabled
Local administration mode is currently enabled.
This allows login without providing the admin
password. Will be disabled after 1 hour or next
reboot.
08081-0 ADM WARNING BUC communication Missing communication between VMU and BUC.
Info: 0x00000001: From VMU to BUC Info:
0x00000002: From BUC to VMU (!T,!V,!S)
08082-0 ADM WARNING Modem configuration
load
Unable to load configuration on modem. Info:
0x00000001: Configuration index invalid
0x00000002: Changing parameter not permitted
0x00000004: Modem not in Remote Mode
(!T,!G,!S)
08083-0 ADM ERROR Vsat Modem network
settings
VSAT Profile activation issue: Modem LAN port
settings rejected
08084-0 ADM WARNING Radome fan
blocked/not rotating
Radome fan is blocked or not rotating even if it
should.
ID Module Type Description Explanation
Table F-1: Event messages (Continued)
To Next Page
Loading...
Need help?
General