USING THE WIZARD
USING THE WIZARD
22 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Adding a Phone call
To continue with adding a Phone call:
1 Press to move to the Phone Number entry.
1 Enter the phone number.
1 Continue from Completing the contact on page 22.
Adding a Get Status call
To continue with adding a Get Status call:
1 Press to move to the Selcall | ALE Address entry.
1 Enter the address of the station that you want to call.
1 Press to move to the Status Type entry, then press .
1 Press or to scroll to the status type that you want to
use, then press OK.
1 If you selected ?: Other as the status type, enter the
text/command that you want to send, press
(Options), scroll to Save, then press (Select).
1 Continue from Completing the contact on page 22.
Completing the contact
To finish entering the information required for the contact:
1 Press to move to the Call Description entry.
By default, the call type is entered as the call description.
1 Enter the description that you want to use for this call.
1 Press (Save) to save the information.
1 If you want to add another call for the contact, press
(Yes), then repeat the steps for adding a call.
If you do not want to add another call, press (No).
To Next Page
Loading...
Need help?
General
