ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
260
Setpoint group General Analog Inputs Related FW 1.9.0
Range [units] the range is defined by analog sensor curve
Default value
the value is defined by
analog sensor curve
Alternative config NO
Step the step is defined by analog sensor curve
Comm object 9278 Related applications AMF, MRS
Config level Standard
Setpoint visibility Visible only if the logical analog input AIN PROT07 (PAGE 610) is configured
Description
Shutdown or BOC threshold level for AIN PROT07 (PAGE 610).
Note: These setpoints are used only if LAI AIN PROT07 (PAGE 610) is adjusted to required protection
type. Otherwise these setpoints are useless.
Analog Protection 7 Sd
6 back to List of setpoints
Setpoint group General Analog Inputs Related FW 1.9.0
Range [units] 0 .. 900 [s]
Default value 0 s Alternative config NO
Step 1 s
Comm object 9279 Related applications AMF, MRS
Config level Standard
Setpoint visibility Visible only if the logical analog input AIN PROT07 (PAGE 610) is configured
Description
Delay for AIN PROT07 (PAGE 610).
Note: These setpoints are used only if LAI AIN PROT07 (PAGE 610) is adjusted to required protection
type. Otherwise these setpoints are useless.
Analog Protection 7 Delay
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65