ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
310
Setpoint group Scheduler Related FW 1.9.0
Range [units] 1 .. 5 [week]
Default value 1 week Alternative config NO
Step 1 week
Comm object 0 Related applications AMF, MRS
Config level Standard
Setpoint visibility Conditioned by the setpoint Timer 1 Function (page 303)
Description
This setpoint adjust the week of month in which the Timer 1 Function (page 303) will be activated.
Timer 1 Repeat Week In Month
6 back to List of setpoints
Subgroup: Timer 2
Setpoint group Scheduler Related FW 1.9.0
Range [units] Disable / No Func / /Auto Run / Mode OFF [-]
Default value No Func Alternative config NO
Step [-]
Comm object 15359 Related applications AMF, MRS
Config level Standard
Setpoint visibility Always
Description
It is possible to choose from following Timer functions. Binary output EXERCISE TIMER 2 (PAGE 571) is
always activated when Timer is active regardless of chosen timer function. Timer functions require controller
running in AUTO mode.
Timer 1 has higher priority over Timer 2. So if Timer 1 Function (page 303) is configured for OFF mode and
Timer 2 Function (page 310) is over the same time configured for AUTO mode, controller will work in OFF
mode.
Controller activates timer whenever it is powered up even in period, where timer should be already running.
Disable The Timer is disabled.
No Func There is no any other function, only binary output of timer is activated.
Auto Run When this option is chosen then the binary output of timer is internally connected to the
REMOTE START/STOP (PAGE 536) binary input.
Mode OFF When this option is chosen then the binary output of timer is internally connected to the
Remote OFF binary input.
Timer 2 Function
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65