ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
324
Setpoint group Geo-Fencing Related FW 1.9.0
Range [units] 0..3600 [s]
Default value 0 s Alternative config NO
Step 1 s
Comm object 14609 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
Delay for Fence 2 Protection (page 326).
Fence 2 Delay
6 back to List of setpoints
Setpoint group Geo-Fencing Related FW 1.9.0
Range [units] Disabled / Enabled / LBI Enable [-]
Default value Disabled Alternative config NO
Step [-]
Comm object 11681 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint enables or disables geo-fencing function.
Disabled Fence 1 Protection (page 325) and Fence 2 Protection (page 326) are disabled.
Enabled Fence 1 Protection (page 325) and Fence 2 Protection (page 326) are enabled.
LBI Enable
Fence 1 Protection (page 325) and Fence 2 Protection (page 326) are enabled only
when logical binary input .GEO-FENCING ENABLED (PAGE 531) is active.
Geo-Fencing
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65