InteliLite
NT
– AMF20/25, SW version 1.2, ©ComAp – March 2008 36
IL-NT-AMF-Reference Guide1.2.pdf
AL Underspeed
Output closes if the gen-set underspeed alarm activates.
The output opens, if
• alarm is not active and
• FAULT RESET is pressed
AL Start Fail
Output closes after the gen-set start-up fails.
The output opens, if
• alarm is not active and
• FAULT RESET is pressed
AL Overcurrent
Output closes if the generator
*IDMT over current or
current unbalance or
short current alarm activates.
The output opens, if
Alarm is not active and
FAULT RESET is pressed
AL BatteryFlat
Output closes when IL-NT performs reset during start procedure (probably due to weak battery) or
when battery under voltage warning appears.
The output opens, if
• alarm is not active and
• FAULT RESET is pressed
AL AI1 Sd
Output closes if the oil pressure (configured to the first analog input) shutdown alarm activates.
The output opens, if
• alarm is not active and
• FAULT RESET is pressed
AL AI1 Wrn
Output closes if the oil pressure (configured to the first analog input) warning alarm activates.
The output opens, if
• alarm is not active and
• FAULT RESET is pressed
AL AI2 Sd
Output closes if the water temperature (configured to the second analog input) shutdown alarm
activates.
The output opens, if
• alarm is not active and
• FAULT RESET is pressed
AL AI2 Wrn
Output closes if the water temperature (configured to the second analog input) warning alarm
activates.
The output opens, if
• alarm is not active and
• FAULT RESET is pressed
To Next Page
Loading...
