ComAp InteliMains NT IM-NT-BB - Page 153

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
153
BASELOAD
The gen-sets are controlled by their load control loops (i.e. as in SPtM)
to provide constant proportional part of the requested system baseload
(see #SysBaseLoad). The InteliMains does not play active role
regarding load control in parallel-to-mains operation.
LOAD CONTROL IN PTM - DISTRIBUTED SYSTEM BASELOAD
LDSHARIN
G
The gen-sets are controlled by the InteliMains through the load sharing
line. The InteliMains load control mode is selected by the setpoint Load
ctrl PtM.