InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
12.1.1.22 Value: Mains V L1-N
Mains voltage in phase L1.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Vm VT ratio.
12.1.1.23 Value: Mains V L2-N
Mains voltage in phase L2.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Vm VT ratio.
12.1.1.24 Value: Mains V L3-N
Mains voltage in phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Vm VT ratio.
To Next Page