InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
12.1.1.25 Value: Mains V
Mains voltage. Average from all three phases.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Vm VT ratio.
12.1.1.26 Value: Mains V L1-L2
Mains voltage between phase L1 and phase L2.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Vm VT ratio.
12.1.1.27 Value: Mains V L2-L3
Mains voltage between phase L2 and phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Vm VT ratio.
To Next Page