InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
12.1.1.28 Value: Mains V L3-L1
Mains voltage between phase L3 and phase L1.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Vm VT ratio.
12.1.1.29 Value: Mains curr L1
Mains current in phase L1.
NOTE:
The ratio between the current measured at the input terminals and the
displayed current is adjusted by the setpoints MainsCTprim and MainsCTsec.
12.1.1.30 Value: Mains curr L2
Mains current in phase L2.
NOTE:
The ratio between the current measured at the input terminals and the
displayed current is adjusted by the setpoints MainsCTprim and MainsCTsec.
To Next Page