ComAp InteliMains NT IM-NT-BB - Page 383

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
383
1
1
0
0
2
0
1
0
3
1
1
0
4
0
0
1
5
1
0
1
6
0
1
1
7
1
1
1
NOTE:
"0" in the table means the input is not active or not configured.
NOTE:
Language index 0 selects the default language of the terminal, i.e. the
language, which is adjusted in the terminal using it's menus.
NOTE:
The reaction on changes of these inputs is delayed about 1 sec to ensure the
new combination is valid (e.g. if a rotary selector switch is used).
CAUTION!
Each language change causes the reinitialization of the display. Function of
the controller is not influenced.
13.2.1.99 Binary input: Lang sel int B
Related FW
standard v3.1.0
Description
This is one of three binary inputs Lang sel int A, Lang sel int B, Lang sel int
C, used for selecting language of the built-in IG-NT terminal (display). As the
IS-NT does not have built-in terminal, this input is assigned to the terminal
(display) #1, which is supposed to be directly attached to the controller or
mounted close to it.
NOTE:
Using these inputs for language selection is an option only. If the inputs are
not configured, the language can be selected using the menus on the
terminal.