ComAp InteliMains NT IM-NT-BB - Page 425

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
425
level. Buttons 1-8 and 9-16 are locked separately.
ON
Pressing the button changes the state of log. binary output
User Button X to closed. When the output is closed and the
button is pressed state is not changed.
OFF
Pressing the button changes the state of log. binary output
User Button X to opened. When the output is opened and
the button is pressed state is not changed.
ON/OFF
Pressing the button changes the state of log. binary output
User Button X to opened or closed depending on previous
state (it is changed to the opposite state).
PULSE ON
Pressing the button issues log. binary output User Button X
to close for time given by setpoint UserBtn pulse.
NOTE:
Repeated pressing of button during the closed period
causes issuing another puls to be generated from the
moment of button pushing.
14.2.1.99 Binary output: User Button 16
Related FW
standard v3.1.0
Description
This output can be specified for example on buttons on IV-5/8 or in SCADA
diagram in InteliMonitor. Its state depends on function assigned to the related
button.
It is possible to lock UserButton commands in configuration to specific user
level. Buttons 1-8 and 9-16 are locked separately.
ON
Pressing the button changes the state of log. binary output
User Button X to closed. When the output is closed and the
button is pressed state is not changed.
OFF
Pressing the button changes the state of log. binary output
User Button X to opened. When the output is opened and
the button is pressed state is not changed.
ON/OFF
Pressing the button changes the state of log. binary output
User Button X to opened or closed depending on previous
state (it is changed to the opposite state).
PULSE ON
Pressing the button issues log. binary output User Button X
to close for time given by setpoint UserBtn pulse.