Setup
Our products are sophisticated multi-source media players. To simplify the setup process as
much as possible, when our models are first started, a “Setup wizard” helps walk you through the
basic steps to enable connections with the different audio sources.
The various listening modes have different requirements:
• Internet Radio requires a suitable Internet broadband connection (usually via a local
wireless network). A broadband service capable of 1Mb download speeds is best.
• Multi-room requires connection to a wireless network.
• Spotify Connect requires connection to a wireless network connected to the internet
along with a paid Spotify Premium account (Musica will also work with free Spotify).
• Music Player requires connection to a wireless network and/or USB connected device.
• DAB/DAB+ (where available)/FM requires a DAB/DAB+ or FM broadcast
signal received via the attached antenna.
• Bluetooth requires a Bluetooth-capable device such as a smart phone or tablet.
• Aux 1 & 2 in requires a connection via the Aux-in sockets with a stereo 3.5mm
audio cable (not included).
• Optical in requires a connection via the Optical in socket with a Toslink cable
(not included).
To start, connect the unit to a suitable power source using the power cord provided. The unit
starts up after a slight delay before the display is initialized.
The unit will normally enter the last used listening mode. The first time they are started (or
after being reset to factory settings) the setup wizard is launched automatically:
Setup wizard
When started for the first time, our models run through a setup
wizard to configure settings for date/time and network. Once
this has finished, the system is ready to use in most modes.
Note: To change these settings later, select Menu >
System settings > and select the required settings option(s)
(see section 0 System settings for further details).
To run the setup wizard again, select Menu > System
settings > Setup wizard.
The Network settings can be reset later manually running the
Network wizard, select Menu > System settings > Network
wizard (see section 0 System settings for further details).
12
To Next Page
Loading...
