Power failure
In the event of a loss of power, a set alarm time will be remembered. However, the alarm cannot
activate if there is no power. If the time has been set to “Update to Network”, and “Keep Network
connected” has also been enabled, then the time and date will automatically be reacquired
within about 3 minutes after WiFi service is restored. Other settings such as Presets will also be
saved during a power loss.
Presets in the Alarm Menu
If you set the alarm source to Internet radio, DAB (if so equipped), or FM, and no Presets have
been set in any of those modes, then the preset list in the alarm menu will show “[Not set]”. For
example, if the alarm is set to wake to FM but the presets contain all Internet radio stations,
then the FM presets in the alarm menu will show as “[Not set]” since there are no FM presets.
Alarm Quick Set
To set the alarms to wake or cancel an alarm without having to turn the unit on and access the
menu, place the unit in standby and simply toggle the alarm key on the remote control. The
bottom of the display will indicate which alarms are active.
Sleep
To set the Sleep timer, press and hold the Menu knob > Main menu > Sleep, and rotate the knob to scroll
through the sleep time options of Off, 15 Mins, 30 Mins, 45 Mins, and 60 Mins. After you select a Sleep
period by briefly pushing in the Menu knob, the display returns to the main menu which will then time out to
the ‘Now playing’ screen after approximately 12 seconds.
On the ‘Now Playing’ screen, the remaining sleep time is displayed at the bottom of the screen.
To cancel Sleep, return to the Menu and select Sleep OFF from the sleep time options.
Note: Sleep is automatically cancelled if Solo or Duetto is put into Standby.
To Next Page
Loading...