11. The Wi-Fi Networks list updates to show available Wi-Fi networks.
12. Select your preferred network from the Wi-Fi Networks list. (Usually your normal
home network).
13. Type in the password (if required) for the network in the Wi-Fi Password box.
14. In the DHCP field, Enabled is selected by default to generate network settings automatically.
Only select ‘Disabled’ if you wish to set the following parameters manually:
a. IP Address
b. Subnet Mask Address
c. Gateway Address
d. DNS Address
15. Keep network Connected - When disabled the network connection is shut down when not in a
network mode. When enabled the network connection is maintained to allow activation/control
from network apps
16. Click Apply.
17. Click OK to confirm you wish to apply the selected settings. The unit restarts and connects to
the preferred network.
18. Setup Complete
The unit’s wireless network is no longer available. Reconnect your computer to the same preferred
home network as you just specified for your unit (this may happen automatically dependent on the
computer set up).
Embedded web pages
Once connected to your network, a web page is available to view status information and make
limited changes via a web browser, run on a smart device or PC, connected to your network.
To connect to the web page enter your unit’s IP address into your web browser. To view the IP
address on your unit’s menu, navigate to: Menu > System Settings > Network > View Settings –
IP address.
To Next Page
Loading...
