• DHCP enabled/disabled
• SSIP
• Authentication
• Encryption type
• Passphrase/key
NetRemote PIN setup
Allows you to define a PIN number to be entered before being able to connect to the unit remotely
over a network so only those who know the PIN number can connect the unit to your network.
Network profile
This displays a list of the networks remembered by the unit (up to a maximum of 4).
Clear network settings
This option will clear current network settings to allow you to join an alternative network. See the
list of registered networks by pressing and holding the Menu knob > System settings >
Network > Network profile >. From here you can delete unwanted networks by rotating and
briefly pressing the Menu knob in, then confirming delete Yes.
Keep Network Connected
This option allows you to define whether the unit remains connected to the network in standby
mode. This is necessary for App operation, audio streaming in Music Player mode, and recapturing
the time after a power outage (if Auto Update from Network is selected). We strongly recommend
keeping the network connected.
c. Time/Date
Set Time/Date
Auto Update
Set Format
Adjust to DST
Standby Clock format
Set Time/Date
The date and time are displayed as dd-mm-yyyy or mm-
dd-yyyy depending on your region, and hh:mm AM/PM
with the first value active (flashing).
Adjust each value with the Menu knob. As each value is
set by briefly pressing the Menu knob in, the next value
becomes ready for adjustment. If the analog clock face is
selected, the date will not be shown in standby mode.
Auto Update
See Page 13.
Set format
Set the time to 12 or 24 hour.
Adjust to DST: Select +1 hour or -1 hour to correctly
adjust the time to the current standard.
24
To Next Page
Loading...