b. Network
- Network wizard
- WPS Wlan setup
- View settings
- Wlan region
- Manual settings
- NetRemote PIN setup
- Network profile
- Clear network settings
- Keep network connected
Network wizard
This guides you through the necessary steps to join a network. This is automatically run as part of
the Setup wizard when you first turn on the unit. The screens and options presented will depend on
the type of network and network protection used.
Our models are compatible with all common network protocols and encryption methods, including
Wi-Fi Protected Setup (WPS). If you reside in a condo, apartment, or dorm building and use
a shared network, you may need the building’s IT person to add the Como Audio model’s
MAC address (System settings > Network > View settings) to allow it to join the network.
To connect to your network, you need a Wi-Fi wireless router and your network’s password (if set).
To select a network use either the Network wizard in the Settings Menu or Manual settings.
WPS Wlan set up
You will be prompted to press the connect button on your router, then press the Menu knob in
briefly to select.
View settings
Displays the settings details for the current network setup, including:
• Active connections
• MAC Address
• WLAN region
• DHCP
• SSID
• IP Address
• Subnet mask
• Gateway address
• Primary DNS
• Secondary DNS
Wlan region
Presents regions to configure the appropriate Wlan behavior. Select the region nearest to the
location in which the unit will be used. When using the Setup Wizard this will be set automatically.
Manual settings
There exist other options for viewing and manually altering network settings by pressing holding
the Menu knob > System settings > Network >. Users experienced with networking may find
these options useful for diagnosing and fixing network problems.
To Next Page
Loading...