EasyManuals Logo

Compaq dc5800 - Microtower PC Reference Guide

Compaq dc5800 - Microtower PC
255 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #236 background imageLoading...
Page #236 background image
Solving CD-ROM and DVD Problems
If you encounter CD-ROM or DVD problems, see the common causes and solutions listed in the
following table or to the documentation that came with the optional device.
Table E-15 Solving CD-ROM and DVD Problems
System will not boot from CD-ROM or DVD drive.
Cause Solution
The device is attached to a SATA port that has been hidden in
the Computer Setup utility.
Run the Computer Setup utility and ensure Device Available
is selected for the device's SATA port in Security > Device
Security.
Removable Media Boot is disabled in the Computer Setup
utility.
Run the Computer Setup utility and enable booting to
removable media in Storage > Storage Options. Ensure CD-
ROM is enabled in Storage > Boot Order.
Network Server Mode is enabled in Computer Setup. Run the Computer Setup utility and disable Network Server
Mode in Security > Password Options.
Non-bootable CD in drive. Try a bootable CD in the drive.
Boot order not correct. Run the Computer Setup utility and change boot sequence
in Storage > Boot Order.
Drive not found (identified).
Cause Solution
Cable could be loose. Check cable connections.
The system may not have automatically recognized a newly
installed device.
See reconfiguration directions in Solving Hardware Installation
Problems on page 220. If the system still does not recognize
the new device, check to see if the device is listed within
Computer Setup. If it is listed, the probable cause is a driver
problem. If it is not listed, the probable cause is a hardware
problem.
If this is a newly installed drive, run the Computer Setup utility
and try adding a POST delay under Advanced > Power-On
Options.
The device is attached to a SATA port that has been hidden in
Computer Setup.
Run the Computer Setup utility and ensure Device Available
is selected for the device's SATA port in Security > Device
Security.
Drive responds slowly immediately after power-up. Run Computer Setup and increase the POST Delay in
Advanced > Power-On Options.
CD-ROM or DVD devices are not detected or driver is not loaded.
Cause
Solution
Drive is not connected properly or not properly configured. See the documentation that came with the optional device.
228 Appendix E Troubleshooting Without Diagnostics

Table of Contents

Other manuals for Compaq dc5800 - Microtower PC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compaq dc5800 - Microtower PC and is the answer not in the manual?

Compaq dc5800 - Microtower PC Specifications

General IconGeneral
ProcessorIntel Core 2 Duo, Intel Pentium Dual-Core, Intel Celeron
MemoryUp to 8 GB DDR2 SDRAM
GraphicsIntegrated Intel Graphics Media Accelerator 3100
Optical DriveDVD-ROM, DVD+/-RW
Form FactorMicrotower
Expansion Slots1 PCI, 2 PCIe x1, 1 PCIe x16
AudioIntegrated High Definition Audio
NetworkIntegrated Gigabit Ethernet
PortsVGA, Serial, Parallel, PS/2, Audio in/out
Operating SystemWindows Vista Business, Windows XP Professional
Power Supply300W
USB Ports8 USB 2.0 (2 front, 6 rear)

Related product manuals